Yellow wire with white stripe

Get answers to Bronco-related technical issues.

Yellow wire with white stripe

Postby phyler » Sun May 01, 2016 12:52 pm

While doing my body work, I found this yellow wire with a white stripe. Anyone know what it should go to?

Image

Image

Image

Sent from my HTC One using Tapatalk
1975 Ranger Edition that I've had longer than I've been without it.
phyler
CCB Admin
 
Posts: 1202
Joined: Sat Oct 02, 2010 8:41 pm
Location: Erie

Re: Yellow wire with white stripe

Postby akaFrankCastle » Sun May 01, 2016 1:19 pm

Fuel tank gauge selector switch.
Stroppe'd
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.

The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.

1973 Stroppe Baja project
User avatar
akaFrankCastle
Official CCB Member
Official CCB Member
 
Posts: 4901
Images: 0
Joined: Wed Oct 27, 2010 5:25 pm
Location: Colorado Springs

Re: Yellow wire with white stripe

Postby Viperwolf1 » Sun May 01, 2016 2:11 pm

It goes to the aux tank sender.
User avatar
Viperwolf1
Official CCB Member
Official CCB Member
 
Posts: 1485
Joined: Tue May 07, 2013 9:37 pm

Re: Yellow wire with white stripe

Postby phyler » Sun May 01, 2016 2:29 pm

Thanks. I'm assuming that since I don't have dual tanks, I can just leave it as it has been? Or is it get voltage? I probably should just put some electrical tape over it and call it good I'm thinking .

Sent from my Venue 8 7840 using Tapatalk
1975 Ranger Edition that I've had longer than I've been without it.
phyler
CCB Admin
 
Posts: 1202
Joined: Sat Oct 02, 2010 8:41 pm
Location: Erie

Re: Yellow wire with white stripe

Postby Viperwolf1 » Sun May 01, 2016 4:47 pm

It's OK as is. The other end is near where the aux tank sender would be.
User avatar
Viperwolf1
Official CCB Member
Official CCB Member
 
Posts: 1485
Joined: Tue May 07, 2013 9:37 pm


Return to General 4x4 Technical

Who is online

Users browsing this forum: No registered users and 3 guests

cron