|
|
It is currently Mon Apr 29, 2024 7:19 am
|
|
Page 1 of 1
|
[ 6 posts ] |
|
| Author |
Message |
|
rlm18
Official CCB Member
Joined: Thu Apr 03, 2014 11:23 am
Posts: 58
Location: Colorado and Arkansas
|
 Engine Identification I am trying to figure out exactly what engine I have to make parts buying easier. I am going to be replacing some seals sometime in the future. I always feel like an idiot at the parts store. "Car make and model? Well....." Looking at old paperwork it could be an 80 - 85 model 302. Supposed to be an 80's model mustang 302 as per the p.o. It has an oil pan with two drain plugs, one front and one rear. Mustang? I pulled the starter to look at the numbers on the engine. E0AE D3C 8 3B2? I have been trying googling decoding. I have not been able to figure out what it all means. A model 80 car 302? Appreciate the help!
You do not have the required permissions to view the files attached to this post.
_________________
74. A few different shades of yellow, black, and rust. 80's 302 w/ edelbrock carb. 80's 4spd on the floor w/ dana 20 twin stick. dana 44 in front and full floating 31 spline ford 9" rear with a detroit locker. 4.56 gearing. 5 1/2" of lift w/ 35" general grabbers.
|
| Thu May 19, 2016 10:12 pm |
|
|
|
akaFrankCastle
Official CCB Member
Joined: Wed Oct 27, 2010 6:25 pm
Posts: 4901
Images: 0
Location: Colorado Springs
|
Re: Engine Identification Appears to be a 1983 casting.
3B2:
3=1983
B=February (B is the second letter in the alphabet, Feb is the second month)
2=day of the month it was cast.
Should still be a 28oz balance motor. Actual vehicle application isn't too important until you get to a water pump or oil pump, in which case you can just ask for something from a Bronco.
_________________
Stroppe'd
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
|
| Thu May 19, 2016 10:28 pm |
|
|
|
Viperwolf1
Official CCB Member
Joined: Tue May 07, 2013 10:37 pm
Posts: 1485
|
Re: Engine Identification
|
| Thu May 19, 2016 11:07 pm |
|
|
|
akaFrankCastle
Official CCB Member
Joined: Wed Oct 27, 2010 6:25 pm
Posts: 4901
Images: 0
Location: Colorado Springs
|
Re: Engine Identification
_________________
Stroppe'd
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
|
| Thu May 19, 2016 11:44 pm |
|
|
|
sykanr0ng
Official CCB Member
Joined: Thu Jan 22, 2015 1:46 am
Posts: 405
Location: Greeley, CO
|
Re: Engine Identification
_________________
"You say overkill like it's a bad thing."
|
| Fri May 20, 2016 3:23 am |
|
|
|
rlm18
Official CCB Member
Joined: Thu Apr 03, 2014 11:23 am
Posts: 58
Location: Colorado and Arkansas
|
Re: Engine Identification Ahhh that's what the 3B2 means. Appreciate it! I'll have to study up on the balance. Thank you again!
_________________
74. A few different shades of yellow, black, and rust. 80's 302 w/ edelbrock carb. 80's 4spd on the floor w/ dana 20 twin stick. dana 44 in front and full floating 31 spline ford 9" rear with a detroit locker. 4.56 gearing. 5 1/2" of lift w/ 35" general grabbers.
|
| Fri May 20, 2016 7:35 pm |
|
|
|
|
|
Page 1 of 1
|
[ 6 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 10 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
