Measurement Needed
- Justin
- Official CCB Member

- Posts: 6199
- Joined: Sat Oct 09, 2010 11:04 pm
Measurement Needed
Would one of you be willing to measure from the interior floor to the highest point on the inside of the roof, ideally without a headliner? Trying to figure out if I can fit my Bronco in my garage with a hard top on it.
- phyler
- CCB Admin
- Posts: 1231
- Joined: Sat Oct 02, 2010 8:41 pm
Re: Measurement Needed
From between the front two seats to the roof is 45.5".
Also, the top of roof is about 6" from the top of the door frame. I laid a straight edge across my roof to get that.
Sent from my Pixel 5 using Tapatalk
Also, the top of roof is about 6" from the top of the door frame. I laid a straight edge across my roof to get that.
Sent from my Pixel 5 using Tapatalk
1975 Ranger Edition that I've had longer than I've been without it.
OG
OG
- Justin
- Official CCB Member

- Posts: 6199
- Joined: Sat Oct 09, 2010 11:04 pm
Re: Measurement Needed
You rock, thanks!
- Jesus_man
- Official CCB Member

- Posts: 5988
- Joined: Thu Nov 11, 2010 9:36 am
Re: Measurement Needed
Ain't no shame in dropping PSI in the tires to get it to fit!! Just sucks if you have to do that daily.
1973 Bronco, 351 SEFI, Locked, discs, 35's ZF-5spd and Atlas 4spd. 235:1 Crawl Ratio. It may be ugly, but it's slow.
http://www.ucora.org
http://www.ucora.org
- Justin
- Official CCB Member

- Posts: 6199
- Joined: Sat Oct 09, 2010 11:04 pm
Re: Measurement Needed
I'm pretty much daily driving it at the moment, otherwise I'd consider it.