intake torque setting's

Post by **71 bass boat** » Sun Mar 13, 2011 2:41 pm

Does anybody know what i should torque my new intake manifold to? and in what order? it's an edlebrok performer if that helps i'm also looking to getting new bolt's for the intake. any info would help thank's!!

matt. beer

Viperwolf1 · Post by **Viperwolf1** » Sun Mar 13, 2011 2:50 pm

It's all on the last page of the instructions: http://www.edelbrock.com/automotive_new ... 0/2121.pdf

Post by **71 bass boat** » Sun Mar 13, 2011 2:57 pm

thank's viperwolf any ideas on the bolts?

Post by **rtreads** » Mon Mar 14, 2011 2:05 pm

...dont use crappy ones. ask me how i know

Viperwolf1 · Post by **Viperwolf1** » Mon Mar 14, 2011 4:53 pm

I used studs for the intake. Ace has them.

Post by **71 bass boat** » Mon Mar 14, 2011 6:48 pm

Oooh what happened with the crappy one's i'm always intersted in a good story!! popcorn

Post by **MOLLEY** » Mon Mar 14, 2011 7:01 pm

mat there is a chilton manual in top draw in garage by da refrig you r welcome to go get it . i think they are 5/16 and 20 to 25 ft lbs .if i remember right . use some sealer around matting surface
cheers . Molley

Post by **MOLLEY** » Mon Mar 14, 2011 7:02 pm

start toward middle and chris cross for pattern
again cheers Molley

Post by **ClayJ** » Tue Mar 15, 2011 9:45 am

Post by **71 bass boat** » Wed Mar 16, 2011 6:32 pm

Sweet thanks for the info guy's. the intake is going back on tonight!! hopefully will have the motor running by the weekend!

www.ColoradoClassicBroncos.com

intake torque setting's

intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's