Need a recommendation!
-
crawlercreations
- Official CCB Member
- Posts: 1101
- Joined: Sat Nov 06, 2010 8:36 pm
Need a recommendation!
My furnace may be dying/dead. I have repaired little issues with it myself several times. My wife just texted saying the blower is not kinking on. We are planning to replace it this summer when it isn't as expensive due to weather! IF we need to replace it now I would like info for a recommendation for someone that isn't going to gouge us on price due to weather. Anyone have a recommendation?? Not sure I am going to have to replace it right now but I would like some information junt in case I have to.
There is a fine line between "hobby" and "mental illness"
-
akaFrankCastle
- Official CCB Member
- Posts: 4901
- Joined: Wed Oct 27, 2010 5:25 pm
Re: Need a recommendation!
This reminds me, I need to talk humidifier systems. We put hard wood floors in a few years ago, and have quite a bit of oak furniture. I had a humidifier installed a few years back and it sucks. The humidity level in the house has never been above 26% since the unit was installed, and I know the humidity level outside the house has been higher than that at times.
Stroppe'd
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
-
akaFrankCastle
- Official CCB Member
- Posts: 4901
- Joined: Wed Oct 27, 2010 5:25 pm
Re: Need a recommendation!
Blast from the past here.
Finally got around to check out the humidifier tonight. Apparently, wiring diagrams are a crutch. Pulled up the proper diagrams from the Honeywell site and...Whataya know! HVAC guy decided to do his own thing with my install. Couldn't even tell you if the thing has put out an ounce of steam since it was installed. Got everything wired up according to the install documents. We'll see how things turn out.
Finally got around to check out the humidifier tonight. Apparently, wiring diagrams are a crutch. Pulled up the proper diagrams from the Honeywell site and...Whataya know! HVAC guy decided to do his own thing with my install. Couldn't even tell you if the thing has put out an ounce of steam since it was installed. Got everything wired up according to the install documents. We'll see how things turn out.
Stroppe'd
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
-
cobshane
- Official CCB Member
- Posts: 516
- Joined: Fri Nov 12, 2010 11:31 pm
Re: Need a recommendation!
akaFrankCastle wrote:Blast from the past here.
Finally got around to check out the humidifier tonight. Apparently, wiring diagrams are a crutch. Pulled up the proper diagrams from the Honeywell site and...Whataya know! HVAC guy decided to do his own thing with my install. Couldn't even tell you if the thing has put out an ounce of steam since it was installed. Got everything wired up according to the install documents. We'll see how things turn out.
Those shady hvac guys. You got watch yourself.
just kidding zilla-
akaFrankCastle
- Official CCB Member
- Posts: 4901
- Joined: Wed Oct 27, 2010 5:25 pm
Re: Need a recommendation!
coberlyshane wrote:akaFrankCastle wrote:Blast from the past here.
Finally got around to check out the humidifier tonight. Apparently, wiring diagrams are a crutch. Pulled up the proper diagrams from the Honeywell site and...Whataya know! HVAC guy decided to do his own thing with my install. Couldn't even tell you if the thing has put out an ounce of steam since it was installed. Got everything wired up according to the install documents. We'll see how things turn out.
Those shady hvac guys. You got watch yourself.
I gotta tell you, if I have any more HVAC issues, Zilla's the man I'm gonna call. If he puts in half as much effort as he does on 4x4 fab, it'd be a damn fine product.
Stroppe'd
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
-
75dlydrvr
- Official CCB Member
- Posts: 140
- Joined: Thu Sep 30, 2010 7:29 pm
Re: Need a recommendation!
I may be calling you too Zill...