Cutting oil
-
Justin
- Official CCB Member
- Posts: 6199
- Joined: Sat Oct 09, 2010 11:04 pm
Cutting oil
Need to get some cutting oil so that I don't destroy Zoso's reamer tomorrow when I reinstall my tie rod. Home Depot doesn't carry it, Ace's is supposed to be really bad. Any suggestions about where to pick up some cutting oil of decent quality, ideally in the northern half of the metro area?
-
ZOSO
- Moderator
- Posts: 3910
- Joined: Mon Nov 15, 2010 4:58 pm
Re: Cutting oil
I've got a big bottle too. Ill be at my dads after work if you wanna get it. He lives a few blocks west from dan.
Rob
74 Ranger EFI351w, 4r70w, ARB 5.13 9in, ARB 5.13D44, and a bunch of other goodies. Best of all the family memories.
04 Mustang Cobra, KenneBell 2.2 feeding a lot of boost on E85. Tire shredding machine
New project: 77 Bronco Ranger, body work and more body work.
Very little left of a 72 durango tan explorer sport
74 Ranger EFI351w, 4r70w, ARB 5.13 9in, ARB 5.13D44, and a bunch of other goodies. Best of all the family memories.
04 Mustang Cobra, KenneBell 2.2 feeding a lot of boost on E85. Tire shredding machine
New project: 77 Bronco Ranger, body work and more body work.
Very little left of a 72 durango tan explorer sport
-
Jesus_man
- Official CCB Member
- Posts: 5988
- Joined: Thu Nov 11, 2010 9:36 am
Re: Cutting oil
Also, the trick with the reamer is to go very very slow. I've had better results from using a ratchet by hand than a drill.
J.D.
J.D.
1973 Bronco, 351 SEFI, Locked, discs, 35's ZF-5spd and Atlas 4spd. 235:1 Crawl Ratio. It may be ugly, but it's slow.
http://www.ucora.org
http://www.ucora.org
-
Jesus_man
- Official CCB Member
- Posts: 5988
- Joined: Thu Nov 11, 2010 9:36 am
Re: Cutting oil
Yep. Seems the smaller bits >3/8" or so do fine with higher speeds, but anything above that and I slow it down!
J.D.
J.D.
1973 Bronco, 351 SEFI, Locked, discs, 35's ZF-5spd and Atlas 4spd. 235:1 Crawl Ratio. It may be ugly, but it's slow.
http://www.ucora.org
http://www.ucora.org
-
Justin
- Official CCB Member
- Posts: 6199
- Joined: Sat Oct 09, 2010 11:04 pm
Re: Cutting oil
Thanks for the advice and offers, guys. I was able to find some while I was down in Denver today. Hope to get it done today or tomorrow.