Power Steering steering shaft?

[totalchaos]

Looking for a steering shaft out of a bronco that had power steering Im converting my 66 bronco from manual to a stock power steering set up and my steering shaft is totally different

[cobshane]

You can use a 3/4 round to a 36 spline ujoint just cut the shaft and weld the smooth part in. I got one at ontrack off santefe road.

[cobshane]

You can use a 3/4 round to a 36 spline ujoint just cut the shaft and weld the smooth part in. I got one at ontrack off santefe road.

Can't remember for if it was 36 spline. You might want to count.

[totalchaos]

You can use a 3/4 round to a 36 spline ujoint just cut the shaft and weld the smooth part in. I got one at ontrack off santefe road.

Can't remember for if it was 36 spline. You might want to count.

Ok Ill check it out and get back with you thanks

[Woodscaper]

I think it is 13/16" x 36 spline on that box.

[cobshane]

I think it is 13/16" x 36 spline on that box.

Ya your right it is 13/16. That's what you need. Alot easier than swapping out a column.

[totalchaos]

I think it is 13/16" x 36 spline on that box.

Ya your right it is 13/16. That's what you need. Alot easier than swapping out a column.

You know where I might find one?

[cobshane]

Ontrack performance off santefe road. Or summit racing. West coast broncos. To name a few.

[totalchaos]

I about have all my steering parts and i think i found that knuckle on ebay but it say 13/16 3/4 by 36 tooth would that be the right one??

[cobshane]

I about have all my steering parts and i think i found that knuckle on ebay but it say 13/16 3/4 by 36 tooth would that be the right one??

That's the one! The 13/16 is the box side with splines, and the 3/4 is the smooth side for were you cut the steering shaft.

[totalchaos]

I about have all my steering parts and i think i found that knuckle on ebay but it say 13/16 3/4 by 36 tooth would that be the right one??

That's the one! The 13/16 is the box side with splines, and the 3/4 is the smooth side for were you cut the steering shaft.

Awesome I just wanted to make sure before I ordered thanks for the help!