Hub Heat- Calipers not fully releasing

[Justin]

Glad you got it sorted!

[landshark]

nice dude! glad you got it sorted and you didn't have to replace any of the big stuff.

[Viperwolf1]

Hey Shawn, do those levis make your butt look fat?

[Rox Crusher]

I can't imagine the hose was the culprit either.

A pinched steel line I could see that but not a rubber hose.

[Gregg]

It wasn't a night / day change. It was just a good improvement. The center hose was starting to deteriorate on the outside and it was the only hose (other than steel) not replaced during the disc conversion. I don't know of any other test other than replacing MC / or calipers. My understanding about the H block is it doesn't change pressure but directs the fluid.

And Viper- No, my butt makes the Levi's look PHAT.

[Justin]

My assumption when I read this was that the hose was deteriorating inside and that some little piece of crud was hanging up when the fluid reversed direction. Greg, you're right about the H block. It isn't a proportioning valve.