So...I got started doing my Explorer EFI conversion Saturday by disassembling my motor down to basically the small block. I noticed the timing chain may have excessive slack in it. I turned the motor to #1 TDC and with the chain tight on the driver side, I have approximately 3/4" of play on the opposite side. This motor only has about 40-50K on it. Time for replacement? If so, what to buy? I at least know I don't need to install the fuel pump eccentric if replaced.
Thoughts?
www.ColoradoClassicBroncos.com
A place for Coloradans to unite with our love of 66-77 Ford Broncos
Timing Chain
6 posts
• Page 1 of 1
Timing Chain
by TOOLMAN » Mon Feb 02, 2015 9:03 am
Wilma - 71 1/2 Wagon; 3 1/2" WH lift, 1" BL, NP435, Chebby disc front, WH twin stick D20, EFI 302, Cool hood scoop, mucho cancer; purchased in 1990.
-
TOOLMAN - Official CCB Member
- Posts: 768
- Joined: Mon Feb 14, 2011 9:29 am
- Location: The MHC
Re: Timing Chain
by Eck » Mon Feb 02, 2015 10:04 am
I just bought this one (http://www.jegs.com/i/COMP+Cams/249/2138/10002/-1) to replace mine. Also-- so you don't make the same mistake I did-- when eliminating the fuel pump eccentric-- make sure you still attach the bolt and washer to the gear and cam.
69 Wagon, 351W, Explorer EFI & Serpentine, ZF5, 35" tires, 3.5 SL, 2 BL, WARN 8274
-
Eck - Official CCB Member
- Posts: 2460
- Joined: Thu Oct 25, 2012 8:33 pm
Re: Timing Chain
by Viperwolf1 » Mon Feb 02, 2015 1:47 pm
3/4" sounds like it's at it's useful limit. Timing chains are cheap.
-
Viperwolf1 - Official CCB Member
- Posts: 1485
- Joined: Tue May 07, 2013 9:37 pm
Re: Timing Chain
by akaFrankCastle » Mon Feb 02, 2015 4:20 pm
X2. It's open already. Might as well get another 100k out of the motor by replacing it.
Stroppe'd
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
-
akaFrankCastle - Official CCB Member
- Posts: 4901
- Images: 0
- Joined: Wed Oct 27, 2010 5:25 pm
- Location: Colorado Springs
Re: Timing Chain
by TOOLMAN » Tue Feb 03, 2015 8:02 am
Measured again last night and I'm at or near the 1/2" play required for replacement. So which do I get? Double roller? True Roller? Something cheap? Billet sprockets? I've never bought one before. I'm surprised (but really not) that this chain only lasted 40-50K. I want to install something that's going to last at least 80K miles!
Wilma - 71 1/2 Wagon; 3 1/2" WH lift, 1" BL, NP435, Chebby disc front, WH twin stick D20, EFI 302, Cool hood scoop, mucho cancer; purchased in 1990.
-
TOOLMAN - Official CCB Member
- Posts: 768
- Joined: Mon Feb 14, 2011 9:29 am
- Location: The MHC
Re: Timing Chain
by Kinder » Tue Feb 03, 2015 9:03 am
It's the chain that wears, so a double roller would likely last longer. Not sure what benefit billet sprockets would add, bling maybe.
Best to Date MPG: 26.6
-
Kinder - Official CCB Member
- Posts: 4371
- Images: 0
- Joined: Wed Sep 29, 2010 9:03 pm
- Location: Parker, CO
6 posts
• Page 1 of 1
Return to General 4x4 Technical
Who is online
Users browsing this forum: No registered users and 0 guests