Ball joint adjusting sleeve

[Justin]

My google-fu is failing miserably. Anyone know where I can get the threaded bushing that fits inside the upper arm of the Dana 44 C to adjust the tension on the ball joints? Anyone have a stock spare?

[landshark]

I think I do. I will look tomorrow. I'm off until thur so might be able to swing by or meet up

[plumbdoctor]

I have 2 laying on the garage floor... If I would have known on sat...

[Justin]

Thanks to both of ya! Keith, I'll take you up on it since I drive past your house 2x/day. When are you around this week? Chris, much appreciated.

[plumbdoctor]

Tomorrow evening , I'll be in the garage...after 5:30

[Justin]

Cool, thanks. I'll text you if I can swing by. Not sure what the day holds.