Tell me the procedure for heater installation

[Unaweep]

Removed, rebuilt the heater box.

Royal pain to reinstall, mainly because the control cables...are short.


Give me the proper procedure and save me some time.

[Justin]

I never found one. Swearing helps.

Actually, you could probably put the cables on, then tighten down the screws on the box. Probably give you a little wiggle room.

[Kinder]

Did you pull the glove box out? It gives you better access and is easy to remove.

[ZOSO]

Just what Justin and Kinder said. Lots of cussing and getting mad.

BTW did you do the blower motor/cage upgrade? It's a must do!

[landshark]

I've pulled mine in and out a few times and it is possible to loop the control lines on before you bolt it to the firewall. I usually put the heater outlets through the firewall lean the box down then reach behind the box like a contortionist and put the ends on. I know there is at least one holder that you screw in and you can get to it but it's a blind loosen/tighten. If that makes sense.

[Dirtheadz]

throw door inserts & doors bars into help the excitment for any underdash needs, the profanity is bound to flow!!! Sure they both are functional and look great but, gaul durn!!!

[Unaweep]

Thanks for all the help. The heater is installed. Cost $74 down at my mechanics shop. I'm at a point in life where time is money and I didn't have the time to mess with it.

Erik

[mickphatmac]

The heater is installed. Cost $74 down at my mechanics shop.

Erik

NICE!!!
Probably the best $74 bucks you've ever spent!

[Unaweep]

The heater is installed. Cost $74 down at my mechanics shop.

Erik

NICE!!!
Probably the best $74 bucks you've ever spent!

It was well worth $74, and the shop also took care of a few other minor things too.

I think I'm going to have them install a new wiring harness soon.

Erik