Trying to figure out how the wiper cover and visors are installed. Anyone have pictures of theirs? Also- where it is actually mounted (screws, bolts?)
Thanks!
Wiper cover install
-
Eck
- Official CCB Member
- Posts: 2462
- Joined: Thu Oct 25, 2012 8:33 pm
Wiper cover install
69 Wagon, 351W, Explorer EFI & Serpentine, ZF5, 35" tires, 3.5 SL, 2 BL, WARN 8274
-
Gregg
- Official CCB Member
- Posts: 1060
- Joined: Sun Nov 07, 2010 10:08 am
Re: Wiper cover install
I remember having to trim the motor cover. I can't remember why but I think it had something to do with the riser and/or the soft top. However the screws holding the cover and visors all matched up.
I remembered. The riser goes straight up and back so the tabs that extend into the front of a hard top had to be trimmed.
I remembered. The riser goes straight up and back so the tabs that extend into the front of a hard top had to be trimmed.
You do not have the required permissions to view the files attached to this post.
Last edited by Gregg on Mon Oct 19, 2015 3:04 pm, edited 1 time in total.
Definition of cool.
-
mickphatmac
- Official CCB Member
- Posts: 1810
- Joined: Fri Mar 16, 2012 9:26 am
Re: Wiper cover install
I think if you have a wiper motor bracket conversion for a soft top it won't fit without trimming.
1968 3.5" Lift on 31's Front serpentine belt ViperBuilt 4x4x2 PS C4 '66 Speedo '66 Horn Button- STROPPE goodies: Steering Wheel, Roll Bar, Cactus Smasher
SOLD :(1972 Explorer Sport - '66 Eyebrow Grill - '66 Speedometer - Stroppe Steering Wheel - Stroppe RollBar - ViperBuilt C4
SOLD :(1972 Explorer Sport - '66 Eyebrow Grill - '66 Speedometer - Stroppe Steering Wheel - Stroppe RollBar - ViperBuilt C4