Odd Sound Question

Post Reply
dcombs
Official CCB Member
Official CCB Member
Posts: 69
Joined: Wed Feb 18, 2015 6:06 pm

Odd Sound Question

Post by dcombs »

Hi Gang,

I was hoping you could help identify where this sound is coming from... it's not in my Bronco but rather my pickup truck -a 69' Dodge.

It's coming from under the truck and usually only happens when I take my foot off the clutch or gas pedal. As soon as I put my on the clutch pedal, it goes away. Oddly, it sometimes it happens when I hit the gas pedal too. Doesn't matter which gear I'm in. It does get louder when turning right.

The clutch is new (I've put maybe 3000 miles on it), the carb is rebuilt, new points, distributor, cap, rotor, spark plugs, alternator, voltage regulator, etc. Also just recently had green bearings put in the rear end with brand new brake drums, pads, hoses, master and wheel cylinder, etc on the brake system. Pretty much everything is new there....

Here's a video/audio clip: http://vid98.photobucket.com/albums/l27 ... ikf060.mp4

Any insight would be appreciated.

Thanks,
Danny
User avatar
Moab Mike
Official CCB Member
Official CCB Member
Posts: 1945
Joined: Mon Jan 03, 2011 1:59 pm

Re: Odd Sound Question

Post by Moab Mike »

When you replaced the clutch did you replace the throw out bearing?
dcombs
Official CCB Member
Official CCB Member
Posts: 69
Joined: Wed Feb 18, 2015 6:06 pm

Re: Odd Sound Question

Post by dcombs »

Yes.

I should mention I checked the u-joints and they seem fine. No movement at all. BUT my driveshaft center bearing has some play. Could that be making the sound?

Thanks,
Danny
User avatar
Moab Mike
Official CCB Member
Official CCB Member
Posts: 1945
Joined: Mon Jan 03, 2011 1:59 pm

Re: Odd Sound Question

Post by Moab Mike »

your center bearing should have no play at all.
dcombs
Official CCB Member
Official CCB Member
Posts: 69
Joined: Wed Feb 18, 2015 6:06 pm

Re: Odd Sound Question

Post by dcombs »

Thanks, Mike. It has quite a bit of play so I'm thinking that's what it is. Does the sound like that to you?

I've never changed one before - can I do it without a hydraulic press?

Thanks,
Danny
User avatar
ZOSO
Moderator
Moderator
Posts: 3910
Joined: Mon Nov 15, 2010 4:58 pm

Re: Odd Sound Question

Post by ZOSO »

did you replace the pilot bearing/bushing?
Rob

74 Ranger EFI351w, 4r70w, ARB 5.13 9in, ARB 5.13D44, and a bunch of other goodies. Best of all the family memories.

04 Mustang Cobra, KenneBell 2.2 feeding a lot of boost on E85. Tire shredding machine

New project: 77 Bronco Ranger, body work and more body work.

Very little left of a 72 durango tan explorer sport
dcombs
Official CCB Member
Official CCB Member
Posts: 69
Joined: Wed Feb 18, 2015 6:06 pm

Re: Odd Sound Question

Post by dcombs »

Zoso, yes. That was my thought too at first. I guess it's possible the new one went bad... I sure hope not. Did it sound like the pilot bearing to you?

Thanks,
Danny
User avatar
ZOSO
Moderator
Moderator
Posts: 3910
Joined: Mon Nov 15, 2010 4:58 pm

Re: Odd Sound Question

Post by ZOSO »

My car had a new pilot bearing failure that sounded very similar.
Rob

74 Ranger EFI351w, 4r70w, ARB 5.13 9in, ARB 5.13D44, and a bunch of other goodies. Best of all the family memories.

04 Mustang Cobra, KenneBell 2.2 feeding a lot of boost on E85. Tire shredding machine

New project: 77 Bronco Ranger, body work and more body work.

Very little left of a 72 durango tan explorer sport
Post Reply