3/4 ton, Dana 44 knuckles/brakes

[pilosopher]

Just throwing this out there: I killed the Dana 44 on my 87 dodge and have upgraded to a dana 60.
And so, I have parts that I dont need.
These are 8 lug assemblies from a light duty 3/4 ton.
I am fairly certain, but havent confirmed that these would bolt up to an EB 44 housing.
I dont see why they wouldnt!
So if youd like an 8 lug, disk brake dana44, here ya go.

-(1pair)Knuckles
-(3)spindles
-(4)hubs/rotors w/bearings (no lockouts)
-(1pair) nearly new brake calipers.

Also a couple of drive flanges that will work on EB 44 hubs. (I keep a drive flange in my 74 in case I bust a hub)

I have no idea on price. Make me an offer! I just dont want to throw good stuff into the scrap bin. Pictures available upon request, of course.
Feel free to call me at 303-349-6753
Dan

[Kinder]

I'm interested in the flanges, can you give me the inner & outer spline count.

[pilosopher]

19 inside, and 48 outside.
I have 2 flanges, but I can only find one of my spacers, and one cap.

[Kinder]

Thanks, but won't work.

[pilosopher]

Why not?
I cant recall the spline count on the EB 44...but for example a new warn hub shares the same part #20990, for the dodge 3/4 ton 44, and the EB.
Maybe i miscounted splines?... For grins, I'll test fit one on my 74 in the next day or two

[Kinder]

I think I need the 30 inner, I'll pull a hub to confirm. They'd be a trail backup for my rear full float.

[pilosopher]

Oh, i see. Well, lemmeknow if ya want em.

I think i'll put this stuff up on (shudder) craigslist and see what kinds of flakey yahoos i can reel in, too.