Starter load test

[phyler]

This isn't Bronco related outside of the fact that both have starters.

My wife's 2008 Toyota Sequoia with the 5.7l died the other night. Only get the tell-tale "click" when you try to start it. Got the starter pulled (that was a PITA, had to drop half the exhaust) but I want to actually test the starter with a load on it.

I did the bench test with a spare battery and verified that the motor would run and what not but there is no load on the unit like a flywheel would create.

Any thoughts? AutoZone's test doesn't actually put load on it.

I don't want to just throw money at this as the starter is $200+ from RockAuto and more at the dealer.

Thanks!

Adam

[Moab Mike]

You can buy a battery load tester at Harbor Freight pretty cheaply.

[horseplay]

A amp clamp meter is the best way to verify the true load the starter is pulling. If you have a multi meter you can check the resistance in you cables and check your Battery voltage at the battery and compare the voltage at the starter for voltage potential.

[phyler]

A amp clamp meter is the best way to verify the true load the starter is pulling. If you have a multi meter you can check the resistance in you cables and check your Battery voltage at the battery and compare the voltage at the starter for voltage potential.

Thanks. I think I understand enough of that to try it. :)

Sent from my Venue 8 7840 using Tapatalk