Rear Leaf Springs

[rt9]

Hi everyone. Probably a stupid question, but, is there a "front" & "back" to install rear leaf springs? I notice the clamp arrangements are different on the ends. These are stock springs.




Sent from my SM-G860P using Tapatalk

[Eck]

Yes

[rt9]

Do these look right?

Sent from my SM-G860P using Tapatalk

[Eck]

I believe they can only go in one way though. There is an alignment pin that holds them in place where the U bolt lines up.

[rt9]

The way I put them on, the front clamp covers 4 leaves and the rear clamp is on 3.

Can someone with stock springs verify this?

It does ride really nice now.[SMILING FACE WITH SMILING EYES]

Sent from my SM-G860P using Tapatalk

[rt9]

That first picture is messed up somehow. Try this.

Sent from my SM-G860P using Tapatalk

[Gunnibronco]

I checked my 66 but the clamps hold 3 leafs on front & rear of the axle. So they must be a different leaf pack. I6vsV8 or GVWR rating?

[rt9]

Yep, probably correct. I think I found the info I needed on the national site. The front mount has the wrap going into the middle of the OD and the rear mount has the spring basically tangent to the OD.

Sent from my SM-G860P using Tapatalk

[rt9]

http://classicbroncos.com/forums/showth ... p?t=170648


Sent from my SM-G860P using Tapatalk