Couple of things

[akaFrankCastle]

Maybe someone is heading this way for the holidays? Worth a shot.

Need a trac bar. Doesn't need to be purty. Just straight and not wallered out. Pre-76.

Axle shafts, inner and outer. Forgot what side. I'll check tomorrow.

Carb. Four barrel. Not looking for anything fancy. You know I'm partial to Eddy's, but really, anything affordable works.

And, if anyone comes across a rust free/dent free hard top, lemme know. Blue paint on top would be even better. But priced well is best.

[pgilbeau]

I will have all the front axle shafts out of my EB width D44 soon.

[akaFrankCastle]

I will have all the front axle shafts out of my EB width D44 soon.

[emoji1303]

[Justin]

Depending on your timeline, I may have my Edelbrock 1604 and intake up for sale in the near-ish future.

[TOOLMAN]

I may have a stock track bar laying around...I'll have to double check.

[pgilbeau]

I also have a non-stock track bar laying around.

[akaFrankCastle]

Outstanding I have a little time to work with. After the holidays I'll be doing final checks on the drivetrain, dropping it in, and test firing. I don't see it needing or being able to move under its own power until the beginning of February, at the earliest.

[ZOSO]

I have a 1406 edelbrock carb and 351w intake to get rid of. Also have the carb jet kit. Willing to separate.

[akaFrankCastle]

I have a possible transportation solution in the works. A friend is driving to Denver/Avon for Christmas and back to Detroit after.

If I can get a PM with some pricing on:
Pgilbeau axle shafts and trac bar
Toolman trac bar
Zoso carb and jet kit

I'll start planning funds and trying to coordinate.

[akaFrankCastle]

December 31 is my window for transportation to pick up. If something won't be available by then, please advise.

[TOOLMAN]

You can have my track bar for the low, low price of...who am I kidding. You can have it. Let me dig through my parts and make sure I didn't just toss it. I usually don't do that, but may have.

[akaFrankCastle]

I'm going to call off the December 31 pick up. Too many moving parts and I don't want people going out of their way. I'll be in Denver from February 3-6 for the Tri State Swap Meet. I'll coordinate to pick up during that visit.

[pgilbeau]

I'm going to call off the December 31 pick up. Too many moving parts and I don't want people going out of their way. I'll be in Denver from February 3-6 for the Tri State Swap Meet. I'll coordinate to pick up during that visit.

Sounds good, I should have the axle shafts soon and will get back to you. Are you just going to the swap meet or getting a booth?

[ZOSO]

I should be around. Maybe even the group swap meet run again.

[akaFrankCastle]

Sounds good, I should have the axle shafts soon and will get back to you. Are you just going to the swap meet or getting a booth?

Just going. This year has been way too chaotic for me to think about setting up a booth. I'd been planning to talk to Don about hauling some stuff up for him but everything on the main level has been booked for months now.