Dana 44 Setup Bearings

[Brent13]

Before I buy, anyone looking to sell?

Thank You

[Brent13]

Well, this went no where. I made a set, so if anyone else is looking, be happy to loan my set out.

[cravenbronco]

[quote="Brent13"]Well, this went no where. I made a set, so if anyone else is looking, be happy to loan my set out.[/quote.

Where are you located at?
Definitely interested.

[Brent13]

Colorado Springs

[cravenbronco]

All I'm needing is the tools to correctly set up the ring and pinion gears.

[Brent13]

I bought them all, inch/pound torque wrench and dial indicator w/mag base, and depth mic, and 200+ foot lbs torque wrench. We could probably work something out. I even made a 9" spanner wrench, and on the other side of the same wrench, custom for holding the yoke while torqueing the pinion to 200 pounds, worked great!

Brent