Can someone please take a quick measurement of the top of the windshield frame? the area where the seal sits for the hardtop/soft-top.
I just need to know the depth at the top of the windshield, ie Front to Back and the approx. center location of bolt holes if possible. assume they are centered.
Need the depth of the windshield frame measured.
-
landshark
- Official CCB Member
- Posts: 3942
- Joined: Thu Oct 13, 2011 11:16 pm
Need the depth of the windshield frame measured.
1976 Bronco "Green, Yellow, whatever", 1969 Bronco "Red", 1972 Bronco Stocker "Kind of Blue/Grayish"
-
Digger
- Official CCB Member
- Posts: 1282
- Joined: Fri Jun 21, 2013 7:53 pm
Re: Need the depth of the windshield frame measured.
I pulled up the model of my windshield frame. (I'm at work)
The depth of the frame (fore/aft) on my truck measured 1.444". The holes were centered, 0.722" from either edge.
Being is was designed in the 60's, my guess is that the target nominal was 1-7/16" (1.4375")
The depth of the frame (fore/aft) on my truck measured 1.444". The holes were centered, 0.722" from either edge.
Being is was designed in the 60's, my guess is that the target nominal was 1-7/16" (1.4375")
Cummins R2.8 diesel, ZF5, AtlasII, HP44/BB9, ARBs, coiled / linked suspension, 37" KO2s, full cage, bumpers, etc.
Build Thread: http://www.coloradoclassicbroncos.com/viewtopic.php?f=3&t=5420
Average 23.5 mpg, Best tank: 26.3 mpg
Build Thread: http://www.coloradoclassicbroncos.com/viewtopic.php?f=3&t=5420
Average 23.5 mpg, Best tank: 26.3 mpg