Pitman Arm Taper Ream

[rt9]

Hi all,,

So I'm getting back to adding power steering to my Bronco. The box I purchased has a pitman arm with a straight bore hole. (different spline count than the original)
Does anyone have a tapered reamer to work with the ball joint or know where I can take this to be machined?
My brother is a machinist, but does not have this particular reamer.

Thanks

Rick

[rt9]

Ok, so I just re-read my post. The hole on the pitman arm that needs taper reamed, is the one for the ball joint on the draglink. Sorry for any confusion.

Sent from my SM-N920P using Tapatalk