Did I somehow break my transmission?

[laffycaffi]

I just replaced the clutch in my 72 Bronco, was excited to take it for a drive, felt like I got the James Duff floor shifter all worked out.

To my surprise, I could only drive in 1st gear. Shifter didn't seem to be working properly even though I had it set up identical to James Duff's own demo video.

First gear - no problem, engages perfectly.

Reverse - suddenly cant get it to engage at all.

Second gear - I managed to get it into 2nd gear by getting under the car and putting it there by hand.

Third gear - I feel like it just won't go all the way into third. I get grinding.

So summary:

1: good

R: can't get it to go into R

2: Seems to work

3: grinding

Any transmission guys out there with any ideas? It was all working fine before I removed the transmission.

While it was out, I cleaned it and rolled it over a few times to get all sides.

It never took any major falls off the trans jack. It kind of rolled off and bumped the ground a few times as I was trying to strap it. But that's it.

I'm terrified that I somehow broke the trans.

Sent from my SM-N950U using Tapatalk

[laffycaffi]

Update - this is weird and I'm exposing my obvious non-understanding of how the clutch and transmission work...

This morning I got underneath the Bronco and with my hand I could move both 1-N-R and back as well as 2-N-3 and back.

I shortened the adjuster rod and again by hand I put it in 2nd and started it up and the clutch seemed engaged, and despite putting my foot on the clutch, the bronco started to drive forward. I considered this a victory.

But then I immediately turned off the engine, went back underneath and tried to change the gear by hand again. Now it feels locked and I cab't move it at all!

Really confused.

[Viperwolf1]

Sounds like you need to adjust the shifter. You probably changed the length of the rods.
https://www.youtube.com/watch?v=ErcSjrxB3J4

[laffycaffi]

Fixed - this was all so helpful . Thanks!