Page 1 of 1
Machining heads
Posted: Sun Aug 21, 2016 9:51 am
by Justin
I need to have my GT40 heads shaved down a little. Anyone have a shop that would do a good job at a reasonable price? Also, any thoughts on what a reasonable price would be?
Re: Machining heads
Posted: Sun Aug 21, 2016 11:40 am
by Kinder
Western Engine Supply off I25 & 70th did the work on W's heads. The prices were reasonable.
Re: Machining heads
Posted: Sun Aug 21, 2016 12:31 pm
by Viperwolf1
Might be a good idea to have the bolt holes enlarged to fit 351w bolts too.
Re: Machining heads
Posted: Sun Aug 21, 2016 1:12 pm
by Justin
Thanks, I'll see what the cost is. I was considering using a hole stretcher.
Re: Machining heads
Posted: Sun Aug 21, 2016 5:02 pm
by ZOSO
usa performance. north of western on washington. it was 150 for up to .015" shaved off. They had it done in just a few hours.