www.ColoradoClassicBroncos.com

So...I just replaced some old recessed can lights with some nice LED retrofits. They are awesome! And BRIGHT! Too bright to leave on at night. So I want to control them a bit better.

Must have:
LED compatible dimming
Dawn-dusk remote sensor

Love to have:
motion sensing with Dual brightness

Here is a kit that has been discontinued, but it would be perfect:
https://www.amazon.com/dp/B001B5QYDU/?t ... sofbo0a-20

Any ideas similar to that?

Is this 110V stuff or Low Voltage (24V) nightscaping stuff?

110v

Sorry...110 lighting is not in my area of expertise.

That's ok. Thanks for trying!

So talk to me about options for this 24v stuff. How easy is it to install for the DIY'er? What's involved? Maybe since I can't locate this switch I need, then perhaps I can go a different route.

Here's a good low voltage nightscaping specification guide that can explain it better than I can in a long post:

http://www.urbanfarmerstore.com/wp-content/uploads/2012/12/lighting1.pdf

I would ignore some of the product specific stuff...I don't know how old this PDF is.

I like FX Luminaire and Vista products specifically. FX Luminaire (which is a subsidiary of Hunter) now offers a residential irrigation controller (PRO-C) that will control your lights as well. But if you want a lot of lights, you may need multiple transformers.

Also keep in mind that some of the higher end fixtures can get pretty pricey!

Hope this helps.

Thanks! I'll do some reading. We've blown our budget (probably many times over) on this house already, so I can't put much into this. But I will see if it's feasible for us and our situation.